Home Decorators Collection 52154 Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Pull off the canopy bottom cover (JJ) from the canopy
□
Loosen the two canopy screws (HH) located on the bottom of the
mounting bracket (A), and turn the canopy counterclockwise
to remove the mounting bracket (A) from the canopy (C).
HH
3
Assembling the fan
NOTE: This fan is equipped with a safety tab. Should the
setscrew (LL) ever become loose while the fan is running
in reverse, the safety tab will engage and stop the fan from
falling.
□
Loosen, but do not remove, the setscrews (LL) on the motor
collar (PP) on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (PP),
and turning it clockwise until it is tight.
□
Re-tighten the setscrews (LL) on the collar on top of the fan-
motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
A
C
JJ
LL
7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
JJ
B
D
E
C
JJ
B
D
PP
E