Stryker System 6 6126-110-000 Manual Del Usuario página 4

EN
Instructions
CAUTION: ALWAYS remove the non-sterile battery
from the aseptic housing before charging the battery.
NOTES:
• Recharge batteries before each surgery, even if
they have not been used, to ensure the maximum
running time.
• The charge cycle takes approximately 5 to
90 minutes.
• The expected run time for each battery is 2.5
to 15 minutes depending on demand procedure
utilization.
• Only use batteries that have been charged within
the last 48 hours.
• Store batteries on the charger where they will
be maintained fully charged. DO NOT store
batteries in handpieces where they will discharge.
Discharge will occur even though the handpiece is
not running.
4
• Charge the batteries at normal room temperature,
approximately 64 to 75 °F (18 to 24 °C).
• Maintenance documentation for this equipment
is available upon request to Stryker-authorized
service personnel only.
• To properly install the battery into a handpiece,
read and understand the appropriate Stryker
handpiece instructions for use.
• To properly charge the battery, read and
understand the instructions for use provided with
the battery charger.
• To install an aseptic battery into an aseptic housing
(REF 6126-120-000), see the System 6 Aseptic
Battery Kit (REF 6126-000-000) instructions for
use.
6126-110-700 Rev-AA
www.stryker.com