Stryker VisionPro Manual Del Usuario página 13

Cable Cover
Installing the Cable Cover
1� Align the left and right hinges of the cable cover onto the bottom rear of the display�
2� Snap on the top section of the cable cover to the aligning clips�
3� With your fingers, turn the thumbscrews clockwise to tighten and lock the cable cover onto
the display�
Removing the Cable Cover
1� With your fingers, turn the thumbscrews counterclockwise to loosen�
2� Once the thumbscrews are completely loosened, pinch the left and right clips and pull the
cable cover towards you�
3� Remove the cable cover from the left and right hinges�
9