Veho MD-2 Manual De Instrucciones página 5

Functions
3
Power On/Off
Power on the radio by pressing the
power button. Power off by pressing
and holding the power button for
approximately 2 seconds.
Standby mode
Enter standby mode by pressing the
'ON/ OFF' button when the radio is in
the 'On' state. Exit standby mode by
pressing the 'ON/ OFF' button when
the radio is in the 'Standby' state.
Time/Date settings
The radio will automatically set the
date and time from your local DAB
signal.
To manually change the time and date
settings, press and hold the 'CLOCK'
button for approximately 2 seconds.
8
Use the skip track controls to set the
time and date, then press the 'ENTER'
button to confirm.
DAB mode
Search for stations by pressing
and holding the 'ENTER' button for
approximately 2 seconds. Use the skip
track controls to skip to the next radio
station, press the 'ENTER' button to
confirm.
FM mode
Enter FM mode by pressing the mode
button until 'FM' is displayed. Use
the skip track controls to search for
radio stations, then press the 'ENTER'
button to confirm.
Auxiliary mode
Connect the 3.5mm audio cord from
your device, then into the MD-2.
Press the mode button until you reach
'Auxiliary Input'.
Bluetooth mode
Press the mode button until you reach
'Bluetooth', this will activate pairing
mode. On your Bluetooth compatible
device, open Bluetooth settings and
select 'Veho MD-2'.
USB Mode
Insert a USB flash drive or connect
a USB audio input cable. Press the
mode button until you reach 'USB'.
SD Mode
Insert a Micro SD card into the
speaker. Press the mode button
until you reach 'SD'. The MD-2 is
compatible with cards up to 32GB in
size.
Adjusting volume
Spin the volume wheel clockwise to
increase volume, or anti-clockwise
to reduce volume. Press down on the
wheel to mute/unmute.
Alarm
To set an alarm, press the 'CLOCK'
button. Select the alarm setup slot
using the skip controls, then press
'ENTER'. Use the skip track buttons
again to select your alarm times, and
press 'ENTER' to confirm settings. The
MD-2 must be in standby mode for
the alarm to sound. Use the 'SNOOZE'
button to temporarily silence the
alarm.
Setting pre-set stations
To set-up a pre-set radio station,
select the station of your choice using
EN
9