Installation
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
Save these instructions for local
inspector's use.
IMPORTANT –
•
Observe all governing codes and ordi-
nances.
Note to Installer –
•
Be sure to leave these instructions with
the Consumer.
Note to Consumer –
•
reference.
• Skill level – Installation of this appliance requires basic me-
chanical skills.
• Completion time – Refrigerator Installation 15 minutes.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered un-
der the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If the refrigerator has an icemaker, it will have to be connected
to a cold water line. An approved water supply kit is available at
extra cost from your local distributor.
Maximum permissible inlet water pressure–8.2 bars. Minimum
permissible inlet water pressure–2.8 bars.
Installation of the icemaker must be done by a qualified service
technician.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature will go
below 16°C because it will not run often enough to maintain
proper temperatures.
• Do not install the refrigerator where the temperature will go
above 43ºC because it will not perform properly.
• Install it on a floor strong enough to support it fully loaded.
38
All manuals and user guides at all-guides.com
Keep these instructions for future
Refrigerator
Models 21, 23, 25, 27 & 29
CLEARANCES
Allow the following clearances for ease of installation, proper
air circulation and plumbing and electrical connections:
• Sides
4 mm
• Top
25 mm
• Back
13 mm
DIMENSIONS
A*
1733 mm
B
908 mm
C**
738 mm
D
1156 mm
E
1214 mm
F
986 mm
G
1355 mm
H
994 mm
*Height does not include hinge.
**Depth includes handle.
A
B
C
D
F
E
H
G