Rampage AV-985A Manual De Operación página 3

All manuals and user guides at all-guides.com
5
LOCAL-DISTANT SWITCH
This two position switch is incorporated to allow maxi-
mum reception in both weak and strong FM signal areas.
When tuned to a weak (distant) station, push the switch
in. This will allow maximum signal to the receiver. When
in an extremely strong signal area (local), release the
switch. This will eliminate all weak signals and suppress
overly strong signals so as to avoid overloading the
receiver input. When moving out of a strong signal area,
return the switch to the "distant" position.
Note: The Local-Distant switch only affects FM signals.
6
MANUAL TUNING CONTROL
Turn the knob either to the left or the right to select a radio
station.
7
ANTENNA TRIMMER
It is very important to adjust the ANTENNA TRIMMER for
optimum AM reception. The antenna trimmer is located
at the back in the tape slot. Tune in a weak station around
1400 KHz and adjust the trimmer with a small screw-
driver for maximum output.
8
DISPLAY PANEL
Displays frequency and time, as well as indicators for
AM, FM, and stereo reception.
9
CASSETTE SLOT
Hold a cassette with the exposed tape edge to the right,
then insert into the cassette slot. Depress fully until the
cassette is engaged and begins playing. When the
cassette reaches the end of play, the unit will automati-
cally change over to radio operation.
bl
FAST-FORWARD/EJECT BUTTON
This button performs two functions. To eject a cassette
simply depress this button fully then release.
cassette will eject and the radio operation will resume.
To fast-forward the tape, depress the button half-way in
to the locked position. To stop fast forward and resume
normal tape playback, depress the button slightly and
release. Do not press fully in or the cassette will eject.
bm
DISPLAY CALL SWITCH
When the unit is turned on, the radio frequency will be
displayed. Pushing this switch will cause the time to be
displayed for about 2 seconds before returning to the
frequency.
bn
HOUR ADJUST BUTTON
This button is used to adjust the hours in the clock mode.
Use a toothpick, pen point or similar item to push the
button.
bo
MINUTE ADJUST BUTTON
This button is used to adjust the minutes in the clock
mode. Use a toothpick, pen point or similar item to push
the button.
SETTING THE CLOCK
1) Turn the unit off or insert a cassette into the cassette
slot to select the clock mode.
2) Push the hour adjust button to adjust the hours.
3) Push the minute adjust button to adjust the minutes.
-2-
The