Tabla de contenido
Publicidad
Step 7 - Install Reflector
Note: lf necessary for proper alignment of
reflector sections, loose each screw prior to
further assembly and retighten after sections are
aligned.
•
Install reflector by using 9 small screws & 9
cap nuts.
Required parts:
Small screw 9 pcs.
Cap nut 9 pcs.
Step 8 - Attach Reflector to Burner
•
Support Heater.
Slide 3 Large flat washers over threaded
•
end of reflector stud.
•
Locate Reflector on 3 reflector studs.
Install Large Flat Washers on Reflector
•
studs & securely tighten wing nuts by hand,
do not over-tighten.
Required parts:
Large flat washer 6 pcs.
Wing nut 3 pcs.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
WARNING
Remove protective cover before assemble
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
