General Characteristics - Sacopa HALOSPOT Guia De Inicio Rapido

IMPORTANT: The instruction manual you are holding includes essential information on the safety measures
to be implemented for installation and start-up. Therefore, the installer as well as the user must read the
instructions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Halospot, follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
Unit spotlight
Bag with wall plugs and screws
Installation and maintenance manual

2. GENERAL CHARACTERISTICS:

This spotlight has been designed to be used fully submerged. It is a Class III electric apparatus with very low safety
voltage.
The spotlight complies with IPX8 degree of protection at a nominal immersion depth of 2 m.
This spotlight complies with international safety standards for lights, especially the EN 60598-2-18 standard: LIGHTS
PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
• The connection boxes should be at least 2 m. from the edge of the water installation.
• The transformer / projector control element should be installed 3.5 m. from the edge of the water installation.
• Conduits installed less than 3.5 m. from the water installation edge, should not be lined or covered in metal.
Place the spotlight on a flat surface. Make sure the base of the spotlight is safe on the mounting location.
Mark the anchorage point on the floor. (Fig. 1)
Drill Ø 7 mm holes.
Place the plugs and fasten the base with the screws supplied (Fig. 2)
To change the angle of the spotlight, loosen the 2 allen screw of the lateral side of the
spotlight with a 2.5 allen wrench, direct it manually and tighten both of the allen screw.
Attention:
• In water installations, ensure the body of the spotlight is located in an accessible place
for easy handling, or make sure it is easily removable.
• Before any handling ensure that there is NO voltage supplied to the spotlight.
E N G L I S H
Fig. 1
2
Fig. 2