Uline H-4406 Manual Del Usuario página 2

1. Attach end caps to seat planks and foot planks.
Make sure the pre-drilled holes on the end caps
are on the underside of the planks. Use a rubber
mallet to tap into place. Attach with a drill and #2
Phillips bit #8 x 1/2" self-tapping stainless screws.
(See Figure 1)
#8 x 1/2" Self-Tapping Screws
2 x 10 Plank (upside down)
Figure 1
2. Assemble X-braces. Use one X-brace with the
notches on the ends and one X-brace without end
notches. Place the pieces together flat side to flat
side. Attach with a 3/8" bolt and flange nut through
the center hole. Hand tighten. Repeat for second
X-brace. (See Figures 2 and 3)
Figure 2
3/8" Bolt and Flange Nut
Figure 3
PAGE 2 OF 12
ASSEMBLY
2 x 10 End Cap
3. Position frames in place, standing up, 6 feet apart.
(See Figure 4)
Figure 4
4a. Working from the back of the frames, attach the
assembled X-brace: notched end to the third hole
up from the bottom and the other end to the right
frame bottom hole. Attach with 3/8" bolts and
flange nuts. Hand tighten. (See Figures 5-8)
Figure 5
Figure 6
Flange Nut
6'
6'
Bleacher Frame
X-Brace
3/8" Bolt
0721 IH-4406