Sony SU-LW1 Manual De Instrucciones página 15

KDL-L32MRX1
1Remove the two screws from the Tabletop
Stand.
KLV-L32MRX1
Note
Do not lay the display down when carrying
out the procedure.
2Holding down the base of the Stand, lift
up the display slightly, then move it away
from the Stand. The display will separate
from the Stand. At least two persons must
hold and carry the display.
Notes
• At least two persons must work together
on this procedure.
• When lifting up the display, hold the base
of the Stand so that it is not lifted along
with the display.
3Remove the two hooks on the rear cover
of the display.
Note
Lay the display face down on a soft cloth.
KLV-L32M1
Note
Lay the display face down on a soft cloth
before going to 1.
1Remove the four screws from the rear
cover of the display.
2Pull the stand towards you. The Stand
will separate from the display.
3Remove the four screws on the rear
cover of the display.
Notes
• Lay the display face down on a stable
and level surface, leaving the base of
the Stand sticking out in the air.
Putting the display face and the base
of the Stand on the same level surface
makes the Display Unit inclined, thus
unstable, causing any danger.
• When removing the Tabletop Stand,
hold it firmly.
Lift up and carry
forward.
2
1
Base of the Stand
3
1
Soft cloth
3
Soft cloth
2
15
(GB)