Additional safety instructions
for your tool
1
Hold power tool by insulated gripping surfaces, when
performing an operation where the fastener may contact
hidden wiring. Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and could give the
operator an electric shock.
2
Battery leakage may occur under extreme usage or temperature
conditions. If battery fluid comes into contact with skin, wash with
soap and water and rinse with lemon juice and vinegar. If the fluid
comes into contact with the eyes, flush with water for several
minutes and contact a doctor immediately.
3
Never burn batteries, they can explode in a fire.
4
Do not charge a leaking battery.
5
Use of an attachment and charger not recommended or sold by the
screwdriver manufacturer may result in a risk of fire, electric shock, or
injury to persons.
6
Before screwing into a wall, in case of doubt check with a metal-/
voltage detector that you are not breaking into an electricity, gas or
water supply lines.
7
Before you lay down the Screwdriver, make sure that all moving parts
have come to a stop.
8
Avoid frequent stalling when screwing or drilling, as this could
damage the batteries.
9
Only connect the charging device to an AC supply.
10
Charge Screwdriver battery only with the appropriate charging device.
11
The charging device and the Screwdriver must be protected from
moisture!
All manuals and user guides at all-guides.com
12
13
14
15
16
1
2
3
4
1
2
3
4
6
Do not use the charging device outdoors.
Do not store or use the tool and battery pack in locations where the
temperature may reach or exceed 39ºC. (Such as outside sheds or
metal building in summer).
Always charge the battery pack between temperatures 2ºC to 30ºC.
Ideal charging temperature is 18ºC to 29ºC.
Do not short out the contacts of battery or charger.
Respect the polarity "+/-" when charging.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR CHARGER
Before using the tool, read the instruction book carefully.
Charger is for indoor use only. Do not expose to rain or water.
Do not charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Safety instructions for battery
pack
Do not dismantle, open or shred secondary cells or battery pack.
Do not expose cells or battery pack to heat or fire. Avoid storage in
direct sunlight.
Do not short-circuit a cell or a battery pack. Do not store cells or
battery pack haphazardly in a box or drawer where they may short-
circuit each other or be short-circuited by other metal objects.
Do not remove a cell or battery from its original battery pack
enclosure required for use.