weltico A800 Folleto De Utilización página 7

FITTING THE CONSTANT LEVEL DIRECTLY TO THE WALL
2
Saw off two lengths of PVC tube of
outside diameter 50 mm according to
the position of the nozzle in relation
to the curb.
Glue the tubes to the elbow and the
assembly to the tank (Beware of the
direction and watertightness)
CONNECTION TO THE OVERFLOW
The constant level has two overflows.You can connect the
PVC tube of diameter 50 mmto one of the overflows or both
of them accordingto your requirements.Use a crown saw
of 40 mm diameter to unblock the overflow. A sleeve or an
elbow is needed for the connection.
Starting the constant level :
1) Connection to suction nozzle via the supplied elbow.
2) Continuous water supply on the side inflow of the
mechanism (top part of the constant level)
1
7 EN
Connect the assembly to the wall nozzle.
Beware of the direction and watertightness
CONSTANT LEVEL ∙ 05/2020