Auxiliary Tools Stored (Fig. 21/22/23); Maintenance; Changing Of The Saw Blade; Maintenance Plan - HOLZMANN MASCHINEN TK 255 Manual De Instrucciones

MAINTENANCE

15.3.8 Auxiliary tools stored (Fig. 21/22/23)

 Loose M6 plastic knob(27)if there is a spare saw blade(7), then hang saw blade (7) in,
tighten M6 plastic knob(27)
 Put rip fence(9) on slot (28a)
 Put push stick(14) or stop rail (24) on slot(29b)
 Coil cable on hook(31)
 Put 2Xwrench(f) and Allen key(30) on tooling box(19)
 Put the whole mitre gauge on slot (28c)
16 MAINTENANCE
Perform all maintenance machine settings with the machine being
disconnected from the power supply!
Serious injury due to unintentional or automatic activation of the
machine!
The machine does not require intense maintenance. However, to ensure a long lifespan, we
strongly recommend following the upkeep and maintenance plan.
Repairs must be carried out by specialists!
16.1

Changing of the saw blade

 Disassemble the saw blade guard (3) (Fig. 9)
 Remove the table insert (8) (Fig. 6).
 Loosen the flange (Fig. 10). In rotational direction oft he saw blade!
 Change saw blade. Observe the rotational direction!
 For the assembly you have to do these steps backwards.
 Before working with the saw again, check the functionality of the guards and the firm seat
of the saw blade.
16.2

Maintenance plan

Loose or lost screws, nuts, bolts
Damage of any part of the machine
Machine cleaning
16.3

Cleaning

Clean the machine from dirt, chippings, etc ... Clean the machine housing with a wet cloth and a
mild cleaning solution.
The usage of solvents, aggressive chemicals or scouring agents damages the
machine housing.
HOLZMANN MASCHINEN GmbH
ATTENTION
Wear safety gloves when you work with saw blades!
www.holzmann-maschinen.at
NOTICE
Regularly prior to each operation
Regularly prior to each operation
Regularly after operation

IMPORTANT

34
TK 255