Maintenance And Periodic Verification; Prohibited Use; Declaration Of Conformity; Transport And Storage - Tractel Dynasafe Mecha 3.2 Manual De Instalación, De Utilización Y De Mantenimiento

Check that the micro switch
Check correct for threshold S2 trips when the
6
operation. "Wire rope slack" condition is
reached.
6. Maintenance and periodic
verification
Tractel recommends to periodically check correct
®
operation of the load limiter and the accuracy of the
threshold settings in accordance with the application
regulations.
No special maintenance is required for this type of
device. When performing periodic inspection, check
that the connecting cable to the control circuit is
properly secured and is in good condition.

7. Prohibited use

Do not:
– Use the load limiter without first becoming familiar
with the user manual.
– Use the load limiter outside the validity periods
defined by the periodic inspection plan to which the
device is subject.
– Use the load limiter if its connection or condition are in
visibly poor condition.
– Shunt the electrical circuit controlled by the device.

8. Declaration of conformity

Copy of declaration conformity in appendix.

9. Transport and storage

During storage and/or transport, the product must be:
– Packed in its original packaging
– Stored in a dry location
– Stored at a temperature between -30°C and 80°C
– Protected from chemical, mechanical or any other
type of attack.
10. Product disposal and environmental
protection
The product must be disposed of in accordance with the
regulations applicable in the country of use.
The different product components must be recycled on
the basis of the table below, after separating metal and
synthetic materials. These materials must be recycled
by specialist organisations.
At the time of disposal, only trained individuals may
dismantle the product to separate its components.
Component
Product body
Micro-switches
Tractel can recycle the product. Please contact
®
Tractel for more information.
®

11. Regulations and standards

The product described in this manual complies with the
following:
European standards
Machinery Directive 2006/42/EC & ISO13849-1
To be treated as a
waste of the type
Aluminium & Steel
Electronics
11
GB