Cutting Height Adjustment - TRAPP MB 51E Manual De Instrucciones

The cutting height is adjusted as follows:
✔
Bend the adjustment rod in the direction
of the wheel (1) to unlock it. After that,
move it either to the right or to the left (2),
according to the height you wish.
✔
There are 9 positions to mow the grass at
the desired height and for the grass
mower to move freely.
1
Fixing the Handle to the Base

Cutting Height Adjustment

2
57
To fix the handle to the base, proceed as
follows:
Take the lower handle (1) and fit the hole (2)
to the support pin (3). Place the locking
clamp (4). After that, take the upper handle
(5) and place the screw (6). Tighten it with
the butterfly nut (7).
Warning!
When adjusting the cutting height, turn
off the motor and check whether the
cutting blade is still turning before
carrying out the adjustment.
✔
To avoid engine overload, select the cutter
edge height according to yard condition.
✔
For the types of grass used in Brazil, it is
recommended to keep them 2 and 3cm
high from soil. If lawn is excessively high,
perform 2 or more cutting with different
height adjustments. This procedure will
help to improve equipment life.
✔
According to cutter model (with or
without grass-holder, with side outlet), use
a cutting sense as shown in the
illustrations below.
ENGLISH