Product Cleaning - Martinelli MILANO Navicella Manual Del Usuario

equipped with a lever under the base which allows the
internal air circulation to be adjusted. Move the lever to
blue for a cool, well-ventilated environment (summer), or
to red to limit the intake of air (winter).
5• CARRIER STRAPS: to move the Navicella bassinet unit,
lower the hood and extract the carrier straps from the side
pockets (fig_a). It can also be carried by the Ganciomatic
handles (fig_b).
Ganciomatic system
6• Ganciomatic is the quick, practical system that makes it
possible to attach the Navicella to the Ganciomatic Base of
the Classico 58.5 chassis (fig_a), the Bassinet Stand (fig_b)
and the Caravell 22 (fig_c) in a single step. The Classico
58.5 chassis, the Bassinet Stand and the Caravell 22 are
available for purchase separately.
To attach the Navicella, put it on the chassis and press with
both hands until it clicks into place.
Always apply the brakes on the chassis before attaching
and removing the Navicella.
Check that the bassinet unit is properly attached.
7• To release the Navicella, move the clip on the Ganciomatic
handle in the direction of arrow_a while pressing it in
(arrow_b) and lift the bassinet unit until it comes free
(arrow_c).
Removing the lining
8• REMOVING THE LINING OF THE Navicella: Unbutton the
cover and the hood. Press the fasteners and pull the hood
upwards to release it (fig_a). Raise the backrest and remove
the mattress pad (fig_b). Unbutton (fig_c) and remove the
inner lining (fig_d).
Padding cleaning instructions
• Brush the fabric parts to remove dust and hand wash at a
maximum temperature of 30° without wringing.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents and do not tumble dry.
All manuals and user guides at all-guides.com
• This product requires a small amount of maintenance.
• Keep all moving parts clean and if necessary lubricate them
• Clean the plastic parts periodically with a damp cloth. Do
• Brush the fabric parts to remove dust.
• Do not clean the polystyrene shock absorbing device with
• Protect the product from atmospheric agents: humidity,
• Store the product in a dry environment.
• CLEANING THE NAVICELLA BASSINET UNIT RAIN COVER:
Car Kit
how to fit the safety harness
9• Fit the Navicella with the backrest and hood lowered.
1 0• When travelling in vehicles, remove any additional mattress
1 1• 3-POINT SAFETY HARNESS: Pass the leg divider straps
1 2• Pass the two ends of the shoulder straps through the slots
1 3• Straps attached under the shell (fig_a) and inside the
ATTACHING THE BASSINET UNIT IN VEHICLES: It is possible
17
Product cleaning
Cleaning and maintenance must only be carried out by
adults.
with light oil.
not use solvents or similar substances.
solvents or other similar products.
rain or snow. Extended exposure to sunshine can cause
colour changes in many materials.
wash with a sponge and soapy water; do not use
detergents.
pads.
through the slot in the mattress pad (fig_a) and the slots
in the shell (fig_b) so that they come out on the other side
(fig_c).
in the mattress pad and the shell (fig_a), then clip them to
the pins (fig_b).
Navicella (fig_b).
Attachment in vehicles with safety belts
to install the bassinet unit in cars if there are 3 rear seats