Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
use (24 months). Further information on
warranty terms can be obtained from
your national Batavus distributor. Please
note that the warranty terms may vary
from one country to another.
Do not attempt any servicing or
adjustments other than those described
in this guide. Everything else must
be left to someone familiar with the
maintenance of electromechanical
equipments and authorised under the
laws of the country in question to carry
out maintenance and repair work.
SAVE THIS INSTRUCTION MANUAL

ASSEMBLY

Start by unpacking the equipment. Two people are
needed for the assembly.
Assembly kit (contents marked with * in the spare
part list): keep the assembly tools, as you may need
them e.g. for adjusting the equipment
If necessary, please contact your dealer with the
model, equipment serial no. and spare part no.
of the missing part. You'll find a spare part list at
the back of this guide. The packaging includes a
silicate bag for absorbing moisture during storage
and transportation. Please dispose of the bag once
you have unpacked the equipment. The directions
left, right, front and back are defined as seen
from the exercising position. Allow at least 100
cm of clearance around the equipment. We also
recommend opening the package and assembling
the product on a protective base.
REAR AND FRONT SUPPORT
Mount the rear foot tube to the base frame using
the screws, the washers and the cap nuts.
All manuals and user guides at all-guides.com
Mount the front foot tube to the base frame in the
same way. Make sure that the rollers for the foot
caps face forward and down during assembly
FRONT TUBE
Push the console cap, which will later be mounted
beneath the console, and the tube cover for the
handlebar shaft onto the handlebar shaft. Then,
push the foam ring for the tube cover onto the
handlebar shaft and push upward.
Connect the top cable to the bottom cable
protruding from the frame tube of the base frame.
Place the handlebar shaft onto the frame tube on
the base frame and fasten it using the screws and
the washers.
Push the tube cover together with the housing
foam ring downward onto the housing.
O W N E R ' S M A N U A L
B A T AV U S C 2
Do not pinch the cable!
CAUTION:
G B
3

Publicidad

Tabla de contenido
loading

Tabla de contenido