Care Instructions - Stryker 8203-026-000 Manual Del Usuario

8203-026-700 Rev-AA
Instructions
To Insert a Wire or Pin
1. Pull and rotate the pre-adjust knob to align the
symbols for the proper wire or pin diameter range.
Make sure the knob retracts and locks in place
after alignment.
NOTE: If the pre-adjust knob is difficult to rotate,
actuating the clamping lever slightly will help.
2. Insert the wire or pin into the nose of the collet,
or through the back of the handpiece, until the
desired length extends from the nose. Make
sure the wire or pin is inserted far enough so the
collet holds the wire or pin before squeezing the
clamping lever.
3. Rotate the shift collar on the handpiece to the drill
mode position.
4. Slide the function switch on the handpiece to the
forward mode position.
5. Squeeze the clamping lever to grasp the wire or
pin.
6. Hold the wire or pin against the bone and depress
the trigger on the handpiece to drive the wire or
pin into the bone.
7. If necessary, perform the following steps to obtain
additional wire or pin length:
7. 1. Release the clamping lever.
www.stryker.com
7. 2. Pull the handpiece back to allow more wire
or pin length.
7. 3. Squeeze the clamping lever.
7. 4. Depress the trigger on the handpiece.
To Remove a Wire or Pin
1. Place the nose of the collet over the free end of
the wire or pin, and then advance the collet as far
as possible.
2. Squeeze the clamping lever to grasp the wire or
pin.
3. Depress the trigger on the handpiece and pull the
handpiece and wire or pin away from the bone.
NOTE: To withdraw threaded pins, slide the handpiece
function switch to the reverse mode position, squeeze
the clamping lever to grasp the pin, and depress the
trigger on the handpiece. (For dual trigger handpieces,
depress the reverse trigger.)
Troubleshooting
See the instructions for use supplied with the
handpiece.

Care Instructions

For processing instructions and disposal/recycle
information, see the care instructions manual supplied
with the handpiece.
EN
7