Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USE INSTRUCTIONS
Read the entire important safety information section at the beginning of this document including all
text under subheadings therein before set up or use of this product.
1. Insert Glue Stick (2) into Glue Gun (1). Plug in Glue Gun and allow to warm up for ten to fifteen
minutes before use.
2. Using clean cloth (not included), clean dent area with Release Agent. Then apply heated glue
from Glue Gun to end of desired Pull Tab (3).
3. Place Pull Tab on center of dent and hold there for ten seconds. WARNING! Do NOT push Pull
Tab against dent.
4. Place Cross Bar (5) over Pull Tab, setting Adjusters (8) to desired length. Thread Wing Nut (6)
onto end of Pull Tab. Continue to twist Wing Nut until dent is raised. Stop when dent returns to
normal surface level.
5. Unthread Wing Nut and remove Cross Bar and Pull Tab from surface. Apply two drops of
Release Agent to spot of dried glue. Use Scraper to peel off softened glue patch.
6. If a high spot has been created, use a hammer (not included) and lightly tap Dowel (7) against
raised spot until desired smoothness is reached.
7. Note: The Repair Kit will not repair ALL kinds of dents, regardless of size. The Repair Kit will also
not work on aluminum panels or surfaces.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
DISPOSAL
Dispose of this product at the end of its working life in compliance with the EU Directive
on Waste Electrical and Electronic Equipment. Contact your local solid waste authority
for recycling information or give the product for disposal to BGS technic KG or to an
electrical appliances retailer.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
Tabla de contenido
