Blanco BLANCOMASTER-S Duo Control HD Información Tecnica Sobre Producto página 7

EinbauMasterControl
Before installation and commissioning
Before the fitting is installed, the intake pipes must
be thoroughly flushed so that no swarf, bits of
hemp or other contaminants can enter the fitting.
Foreign bodies can enter the fitting through pipes
which have not been flushed, or the water system
in general, and damage the ceramic disks and
O-rings. The installation of a dirt filter is recom-
mended in all cases.
Before commissioning the fitting, unscrew the jet
regulator and flush well.
Installation
BLANCOMASTER Control requires a tap borehole
(diameter symbol) 35 mm; a further borehole (dia-
meter symbol) 35 mm is required for BLANCO-
MASTER-S Duo Control. Flush all pipes well in
order to remove the dirt residues. Position the kit-
chen fitting in the opening and ensure that there is
a seal between the fitting and the surface on
which it sits. In the case of stainless steel sinks,
mount the stabilising triangle from underneath
against the sink to increase the stability. Fasten
the fitting with the mounting set (seal, washer,
nut). Fasten the flexi-hoses (with the seals) to the
hot and cold water pipe. Make sure that when the
nuts are tightened, the connection pipes are firmly
held to prevent them becoming twisted or deta-
ched from the body of the fitting.
Only BLANCOMASTER-S Duo Control:
Mount the hand spray mounting set (26) in the
second tap hole. Screw together hose spray and
spray hose and insert the free end of the spray
hose from above into the mounting set. Connect
spray hose (19) with nonreturn head (17) and
seals (23) to flexi-hose.
Finally, hook Bowden cable as per Figure
into the drawbar of the fitting and secure.
13.07.2005 16:55 Uhr
3
Seite 8
Important information
• Do not kink the flexi-hoses
• Do not strain the flexi-hoses
• Only screw the flexi-hoses manually into the
body of the fitting.
• When connecting the flexi-hoses to the angle
valves, they must be held firmly to prevent the
hoses becoming twisted or detached from the
body of the fitting.
Maintanance
Jet regulator
1. Loosen jet regulator (12)
2. Flush jet regulator sieve under flowing water
3. Reinsert jet regulator
Replacing the cartridge
1. Shut off cold and hot water supply at the angle
valve
2. Loosen coloured cap (3) and the holding
screw (2) of the lever (1)
3. Remove lever
4. Remove the cartridge lock nut (4)
5. Remove cartridge (6) and replace
6. Assemble in reverse order
Care
In order that your BLANCO kitchen fitting will pro-
vide you with years of pleasure, we recommend it
is cleaned by wiping regularly with a soft cloth
(BLANCO microfibre cloth is recommended). Use
clean water or a mild cleaning agent.
On no account should abrasive (neither liquid nor
powder) cleaning agents or those containing alco-
hol or acid-based or other "aggressive" agents be
used. Scouring sponges are equally unsuitable.
The use of proscribed cleaning agents can dama-
ge the finish. Such damage is not covered by the
guarantee.
Guarantee
If a claim is made on the guarantee, the claimant
must produce the invoice on which the date of
purchase or installation is stated.
We reserve the right to make technical changes.
5