Pleasant Hearth OFW821RC Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
2. Place the firebowl (E) on its side on a smooth,
clean surface. Attach one air vent (D) by
inserting two M6 x 12mm bolts (AA) through
the pre-drilled holes in the firebowl (E) and the
air vent (D) as illustrated. Repeat with the
remaining air vents (D). Tighten all bolts with a
screwdriver.
Hardware Used
AA M6 x 12mm Bolt
3. Attach the legs (F and G) to the firebowl (E)
by inserting eight M6 x 12mm bolts (AA) through
the pre-drilled holes in the firebowl (E) and the
legs (F and G) as illustrated. Tighten all bolts with a
screwdriver.
Hardware Used
AA
M6 x 12mm Bolt
4. Insert the threaded pegs (CC) into the firebowl(E)
as illustrated and hand tighten.
Hardware Used
Threaded Peg
CC
2
D
x 6
D
3
x 8
4
x 4
5
AA
AA
E
E
G
G
AA
AA
F
F
CC
CC
E
E
E
E