Safety Information - Baratza SETTE 30 AP Guia De Inicio Rapido

®
Bag of Tools:
We have included a small bag with a 5mm hex key and burr
shims for calibration. Installing a shim is only needed if the
grind at setting 1 is not quite fine enough. In our experience,
installation of a shim is generally needed after 1-2 kilos of
espresso grinding, but may be needed before that. Shimming
will likely be needed, at some point, based on use.
When needed, installation of just 1 shim is recommended
and will shift the grind finer by about 6 settings. Installing 2
shims at once can shift the grind range to be so fine that it
causes undue stress.
Detailed shimming instructions can be found in the full
manual, at the link on the right.

SAFETY INFORMATION:

Please read the information below very carefully. It contains important safety information for this appliance.
Please keep these instructions for future reference.
!
Use only with AC current and the correct voltage.
See the label on the base of the grinder to determine
the correct voltage.
!
Only clean the grinder housing with a dry or slightly damp
cloth. Do not immerse the grinder, plug or cord in water or
any other liquid.
!
Baratza will not accept any liability for damage, injury, or
warranty if the grinder is used other than for its intended
purpose (i.e. grinding roasted whole coffee beans) or is
improperly operated or repaired.
!
Keep the appliance and its cord out of reach of children
aged less than 8 years
!
Do not operate the grinder with a damaged cord or plug.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard
CAUTION: ALWAYS unplug the electrical supply cord prior to cleaning the grinder.
All manuals and user guides at all-guides.com
SETTE™ 30 AP QUICK START GUIDE
Still Need Help?
If you have any questions or concerns, please email:
support@baratza.com
The full manual can be found on our website at:
baratza.com/documentation
For video instructions and troubleshooting guides:
baratza.com/troubleshooting
!
Do not leave your grinder unattended while turned ON.
!
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved.
!
Cleaning and user maintenance shall not be made by
children without supervision.
!
Always unplug the grinder from the electrical supply
before assembling, disassembling or cleaning.
!
To unplug, grasp plug and remove from the outlet. Never
pull on the cord.
Rev 7/26/2017 (v2)