Hart VP205-C-3701 Manual Del Operador página 8

OPERATION
• Verify that the power cord is disconnected from
the outlet.
• In order to prepare your vacuum for dry
vacuuming, make sure the reusable cloth
filter completely covers the filter cage against
the power head. Your wet/dry vacuum comes
with the reusable cloth filter pre-installed. For
installation instructions, see page 12.
• Place the power head back on the collection
tank and secure it in place using the latches.
• Insert the locking end of the hose into the
vacuum port on the collection tank and lock
into place.
• Push the required attachment onto the free end
of the hose.
• Verify that the switch is in the 'O' OFF position
before plugging the power cord into the power
outlet. Plug the power cord into the outlet.
• Turn the motor on by flipping the switch to the
'I' ON position and begin vacuuming.
• Once you have completed vacuuming, flip the
switch to the 'O' OFF position and unplug the
power cord from the outlet.
O = OFF I = ON
DO NOT USE THE REUSABLE CLOTH FILTER
FOR LIQUID VACUUMING.
LIQUID VACUUMING
See Figures 18-23.
WARNING:
Be sure to read, understand, and apply information
entitled "SAFETY INFORMATION". Do not vacuum
in areas with flammable gases, vapors, or explosive
dusts in the air. Flammable gases or vapors include but
are not limited to: lighter fluid, solvent type cleaners,
oil-based paints, gasoline, alcohol, or aerosol sprays.
Explosive dusts include but are not limited to: coal,
magnesium, grain, or gun powder. To reduce the risk
of health hazards from vapors or dust, do not vacuum
toxic materials.
WARNING:
Do not plug the power cord into the power outlet.
Make sure the plug is disconnected before changing
the filters.
• Verify that the power cord is disconnected from
the outlet. Make sure that the collection tank is
clean and free of dust and dirt.
• Remove the reusable cloth filter, then carefully
install the foam wet filter over the filter cage and
place the power head back on the collection
tank. For foam wet filter installation instructions,
see page 13.
DO NOT USE THE REUSABLE CLOTH FILTER
FOR LIQUID VACUUMING.
• Insert the locking end of the hose into the
vacuum port on the collection tank and lock
into place.
• Push the required attachment onto the free end
of the hose.
• Verify that the switch is in the 'O' OFF position
before plugging the power cord into the power
outlet. Plug the power cord into the outlet.
• Turn the motor on by flipping the switch to the
'I' ON position.
• Once you have completed vacuuming, flip the
switch to the 'O' OFF position and unplug the
power cord from the outlet.
• After use, empty the collection tank. Drain
liquids into a suitable receptacle or drain. Once
the collection tank is cleaned and dried, refit the
power head to the collection tank.
IMPORTANT! When vacuuming large quantities
of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle
opening to allow air inflow. The machine is fitted
with a float valve that stops the suction action
when the collection tank reaches its maximum
capacity. You will notice an increase in motor
speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid
into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection
tank. After wet vacuuming, turn the machine off
and remove plug from power supply. Empty the
collection tank, clean, and dry the inside and
outside before storage.
REMEMBER! The foam wet filter must be removed
after wet vacuuming and the reusable cloth filter
must be installed before dry vacuuming again.
FIG. 18
8 English