Weller WRS 1002 Instrucciones Para El Manejo página 9

equipment have been removed.
18. Avoid unintentional operation.
Please make sure that the switch is set off, when connection the plug to the wall
outlet, respectively when connection the equipment to the mains. Do not carry the
soldering equipment connected up to the mains with the finger on the master switch.
19. Be attentive.
Watch out what you are doing. Be sensible in working. Do not use the soldering
equipment, if you cannot concentrate on your work.
20. Check the soldering equipment for potential damage.
Before using the soldering equipment again, please check the safety devices or
slightly damaged parts for perfect function as required. Please check whether the
moveable parts work perfectly and do not jam or whether parts are damaged. All parts
have to be fitted correctly and have to meet all conditions in order to safeguard perfect
operation of the soldering equipment. Damaged safety devices and parts have to be
repaired or replaced in an expert manner by an authorised specialist workshop unless
nothing to the contrary has been stipulated in the operating instructions.
21. Warning.
Please only use the accessories or optional devices which are mentioned in the list of
accessories in the operating instructions. Use Weller accessories or optional devices
on original Weller equipment only. The use of other tools and other accessories may
cause injuries.
22. Please have your soldering equipment repaired by an electric expert only.
This soldering equipment corresponds to the pertinent safety regulations. Repairs my
be carried out by an electric fitter only, using original Weller spare parts only,
otherwise the operator may have an accident.
23. Do not work on live parts.
The handle is conductive on antistatic soldering equipment.
24. Do not connect any combustible gases.
No combustible gases may be connected to hot-air, respectively hot-gas devices. Do
not point the hot gas jet at persons, respectively do not look into the hot-gas jet.
Provide for sufficient ventilation in case of internal gases.
25. Use in combination with other Weller devices.
If the soldering equipment is used in combination with other Weller devices,
respectively accessories, the warning notes mentioned in those operating instructions
are appliance as well.
26. Please observe the safety regulations appliance for your workplace.
7