Connecting with Bluetooth
Go to the Bluetooth settings of
your device and select the Play-Fi
speaker name.
The Bluetooth indicator will begin blinking two times per second when
pairing is in progress (Fig. 3).
When the connection is successful, the Bluetooth indicator on the Wren
speaker will turn solid blue (Fig. 4).
blinking
amber
Figure 3 • Pairing
Once your device has paired with the Wren speaker, you will not need to
pair it again. You will be able to connect and disconnect using your device's
Bluetooth settings.
For more information on connecting with and using Bluetooth, see the
section on Bluetooth in the Setup Guide.
10
All manuals and user guides at all-guides.com
(Continued)
solid
blue
Figure 4 • Connected
Troubleshooting tips
WiFi light is not blinking
amber slowly (once per
Solution
second) during setup.
The speaker is already connected to your WiFi network. Go to
WiFi indicator is solid white.
the speaker settings in the app and select your Wren Speaker.
Put the speaker into setup mode by holding the setup button
WiFi indicator is blinking
on the back panel for about 7 seconds. Release when the
faster than once per second.
amber light blinks slowly (once per second).
The speaker is in WPS setup mode; if you are not using WPS
WiFi light is double-blinking
for setup, press and release the source button once. (For more
two times every second.
on WPS, see the Setup Guide.)
Setup Fails
Solution
If setup fails multiple times,
the speaker may be too far
Move your speaker closer to the router.
from your router.
If you need any help with set-up, consult the Setup Guide included with your speaker or visit
our website at
http://wrensound.com/support/V5us
customer support.
to view troubleshooting or to contact our
11