Garbin 25GE VAP Manual De Instrucciones página 43

39
3.2.1a - MODELS
25GE VAP / 45GE VAP / 46PE VAP / 61GE VAP / 64PE VAP / 101GE VAP / 104PEVAP
SWITCHING ON/OFF
When power is connected, the panel shows the software version
message for a few seconds. Then the oven switches itself OFF,
the LED on the time display lights up and the oven remains in
standby.
Pressing ON/OFF:
turns on the panel:
all the displays come on: the temperature display flashes waiting
for the set point to be entered:
default temperature 100 °C,
default timer 000,
default humidity 0,
MA default program display (manual oven mode).
Once the temperature has been set by pressing the + or -
buttons, the display continues to flash for 15 seconds and then
accepts the data entered, or, by pressing the temperature button,
the data entered is accepted immediately, the display shows
the fixed set point and the time display flashes automatically.
Once the time has been set by pressing the + or - buttons, the
display continues to flash for 15 seconds and then accepts the
data entered, or, by pressing the time button, the data is
accepted immediately, the display shows the fixed set point and
the humidity display flashes automatically.
Once the humidity data has been set by pressing the + or -
buttons, the display continues to flash for 15 seconds and then
accepts the data entered, or, by pressing the humidity button,
the data is accepted immediately.
At this point, all the displays are fixed, showing the data set.
The programs display remains fixed in the MA position and does
not flash unless the P button is pressed to enter programming
mode.
During the cooking cycle, it is possible, while altering the set
parameters, pressing the corresponding button (temperature,
time, humidity) and using the + and - buttons, to change the
parameters, waiting for 15 seconds or pressing the
corresponding button and the program does not automatically
move to the next data as with the initial phase.
If the oven is in stop mode and no operation is performed for
more than 15 minutes, the oven automatically switches off as if
the OFF button had been pressed.
The ON/OFF button is disabled during a cooking cycle. To make
it active, you must first press the START/STOP button.
When the oven goes off, either because the ON/OFF button
has been pressed or at the end of a cooking cycle, the last set
parameters are stored for 5 minutes. 5 minutes after switch-off,
pict. 13
the panel returns to MA (manual) mode when switched back
on.
GB
ELECTRIC VENTILATED OVENS