Water Drain; Accessories Connections; (Prover, Hood, Blast Chiller, Etc.) - Unox ChefTop Gas Manual De Instrucciones

ChefTop™ - BakerTop™ ChefTop™
6.2 WATER DRAIN
You find the waste outlet pipe on the rear of the oven. It
has to be connected to an open tundish drain in compli-
ance with current regulations through a rigid or flexible
heat resistant pipe; the diameter of the pipe cannot be
smaller than diameter of the drain connection. The length
of the pipe cannot be longer than one metre.
Avoid reductions in diameter and tight bends along the
whole length of the waste pipe run.
The waste pipe must remain at least 20 cm below the
drain connection to allow the liquids to drain.
6.3 COOKING CHAMBER EXHAUST
The exhaust outlet of the cooking chamber is positioned
on the rear of the oven, at the top.
Do not stack any object and or material on the outlet as
this could cause a blockage of the fumes. Please ensure
that the exhaust outlet is correctly vented and the vicinity
of the outlet is clear of objects and materials that may be
damaged by the fumes.
It is suggested to place the oven below an extraction
hood or to install the UNOX aspiration hood, code
XC314 for ChefTop™- XC414 for BakerTop™, or the
UNOX steam condenser, code XC114. In all installations
please extract the fumes through the UNOX tube, code
TB1520A0, avoiding tight bends in the pipework run.
ENGLISH
25
7. ACCESSORIES CONNECTIONS (PROV-
ER, HOOD, BLAST CHILLER, ETC.)
The digital board of the oven controls all the accessories
(hood, holding cabinet, blast chiller, reverse osmosis system).
The accessories controlled by the oven are connected
through RJ45 connectors that are positioned on the rear
of the oven.
To connect the cables proceed as follows:
• remove the protection cover to enter the electrical
system
• by using a cutter make a vertical cut on one of the rub-
ber caps placed on the panel on the back of the oven
• enter an end of the RJ45 cable through the cut on the
rubber cap
• connect the cable end with the proper female connec-
tor on the power card (you can use any one of the three
connectors)
• replace the protection cover by fixing the screw
Now the accessory is recognized and connected to the
oven
Please refer to relevant instructions manual for the cor-
rect use ot the connected accessory