System Control Panel; Menu - Briggs & Stratton 040517 Manual Del Operador

System Control Panel

The generator control board, located inside the generator,
under the roof, is shown below. Brief descriptions of the
controls used during installation are:
A
- Menu/Programming Navigation Buttons — See
Menu section for details
B
- USB Port — Authorized Dealer Service Use Only.
C
- Generator Operation Control Buttons —
• "AUTO" Normal operating position. Press and hold
button to put unit into Automatic mode. In Automatic
mode, if a utility power outage is sensed, the
system will start the generator. When utility power
is restored, auto lets the engine stabilize internal
temperatures, shuts off the generator, and waits for
the next utility outage.
• "OFF" Turns off running generator and resets any
detected service codes.
NOTICE OFF must be pressed and held for more than 5
seconds in order to reset service code.
A
B
C
14
• "MANUAL" Used to manually start the generator.
*
D
E
F
More information may be found in Controls in the
operator's manual.

MENU

ESC
AUTO OFF
*
- "AUTO" LED — LED will light when unit is placed
into Auto mode. LED will blink if exercise cycle is not
set or set to OFF.
– 15 Amp Fuse — Protects the home generator DC
control circuits. If the fuse has 'blown' (melted open)
or was removed, the engine cannot crank or start.
Replace the fuse using only an identical ATO 15A
fuse. One spare fuse is supplied with the unit.
- Cover — This protective cover must be opened to
access the fuse and the USB port.
- Digital Display — Displays generator mode,
menu options, service codes, and service engine
indicators
MANUAL
F
E
D