Operating Instructions For The Speedometer - SHERCO 50 SE 2022 Manual Del Propietário

OPERATING THE VEHICLE

OPERATING INSTRUCTIONS FOR THE SPEEDOMETER

MODE button
IGNITION
- Starting the bike:
- The meter performs its ignition procedure (all the
lights light up briefly) and stay on.
- Wheel spin: the meter will turn on and will remain
on for 30 seconds if no speed pulse is regenerated.
- Press a button: the meter will light up and will stay
on for 30 seconds if no button is pressed.
SPEED
Speed and speed units (km / h or mph) are
permanently displayed.
The speed can vary from 0 to 199 in both cases.
DISPLAY
Scroll between displays:
Press SET <2 seconds: Displays the trip time or
the km.
Press SET > 10 seconds: change units km / h - mph.
Press MODE <2 seconds: Displays the total, the
trip A, the trip B.
Press MODE > 10 seconds: allows you to enter
the wheel mode.
Press MODE & SET > 2 seconds: allows you to
enter clock mode.
CLOCK
Format :
If units are in km 24 h
If units are in mph 12 o'clock
Press MODE <2 seconds: increases the hour value.
Press MODE > 2 seconds: quickly increases the
time value.
Press SET < 2 seconds: increases the minute value.
Press SET > 2 seconds: quickly increases the
minute value.
Press MODE & SET > 2 seconds: leaves The clock
mode and saves the values.
NO ACTION > 10 seconds: automatically exits clock
mode without saving.
TRIP A & TRIP B
Press MODE < 2 seconds: choice of trip.
Appui sur SET < 2 seconds: Displays the time of use
or distance traveled.
Press SET > 2 seconds: reset.
WHEEL SIZE CONFIGURATION
Press MODE < 2 seconds to change the size of
the wheel (50SM = 1850 / 50EN = 2070 / XY-TY
= 2190).
Press MODE & SET > 2 seconds: leaves the wheel
mode and saves the values.
NO ACTION > 10 seconds: automatically exits
without saving.
SET button
77