Installing The Blades - Home Decorators Collection 52027 Guía De Uso Y Cuidado

Assembly - Hanging the Fan (continued)
7
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
□
Align the locking slots of the canopy (C) with the two screws
(II) in the mounting bracket (A). Push up to engage the slots
and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (II).
□
Install the two canopy screws (HH) (saved from Assembly Step
1 "Preparing for mounting") into the holes in the canopy (C)
and tighten firmly.
□
Install the decorative canopy ring (EE) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
8

Installing the blades

□
Attach a blade (G) to the fan motor assembly (E) by inserting
the blade (G) into slots in the side of the fan motor assembly
(E) and aligning the three screw holes in the blade with the
holes in the center flywheel and secure with screws (AA).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
II
C
11
Please contact 1-800-986-3460 for further assistance.
A
HH
EE
D
E
E G
AA
HOMEDEPOT.COM/HOMEDECORATORS