Assembly; Installing The Receiver - Home Decorators Collection 52027 Guía De Uso Y Cuidado

Assembly - Hanging the Fan (continued)
3
Setting the code on the remote
control and receiver
NOTE: The frequencies on your receiver and hand unit have
been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and hand unit are
set to the same frequency. The dip switches on the hand unit
are located inside the battery compartment.
NOTE: The switch marked "O/D" controls the dimming
function of the lights. If using non-dimmable bulbs, use a
ballpoint pen or small screwdriver to set the switch to "O" to
disable the dimming function. If using dimmable bulbs, set
the switch to "D" to enable the dimming function.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place, as this will damage the
hand unit. Dispose of the used battery properly and keep the
battery out of the reach of children.
□
Remove the remote control (K) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or
down. The factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (J) to the same
position as set on the remote control (K).
□
Install the 23A 12V batteries (included).
□
Replace the battery cover on the remote control (K).
□
Insert the silicone rubber stopper (OO) into the hole on the
receiver (J) to cover the dip switches.
4

Installing the receiver

WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
□
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A); position the fan wires (BBB)
to the opposite side.
□
Insert the narrow end of the receiver (J) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket (A)
until it rests on top of the ball/downrod assembly (B).
J
AAA
9
Please contact 1-800-986-3460 for further assistance.
O
D
ZZ
K
OO
Receiver (J) correctly
positioned in the
mounting bracket.
J
J
BBB
B
C
HOMEDEPOT.COM/HOMEDECORATORS