Remote Control; Select Source - Onix OC103 Guia Del Usuario

Remote Control

Move the switch to CD/AMP
Direct selection digits
Fast rewind/fast forward keys
Previous/next keys
Display area brightness regulating key
To operate the remote
control requires two battery of
AAA 1.5 V, which are not included.
Preparation
1. Firstly connect the device properly.
2. Push the power switch on the rear panel into the location of "ON", then the "ON/STANDBY" indicator lamp on the
panel will be on in red. In such case, touch any location on the metal strip on the touch panel after one second or the
〈 〉key on the remote controller, then the indicator lamp will turn green. After about 3s, the relay will make. then the
device will enter the normal work state.
3. To power off this device, touch any location on the metal strip on the touch panel after one second or the〈 〉key on
the remote controller, then the indicator lamp will turn red and the device will be in the standby state; then push the
power switch on the rear panel to the location of OFF to turn off this device.
4. If this device is idle for long, be sure to unplug the AC power cord from the device.

Select source

Press〈CD INPUT〉button on the remote control, then the display on the front panel will show the following text
Read USB
Play the disc
1. Opening the disc cover by push back it slowly, put disc clamp on the disc, and close the disc cover by manual.
2. Once the loader is started, screen shall display area total tracks and time.
3. Press〈 〉button on machine or key on remote control to play all contents on the disc.
4
Selector switch
Stop key
Play/pause key
IPOD OPTI
/ C D /
DAC T U N E R C D
/
C D A M P S A C D I N P U T
IN P U T L E V E L
1 2 3 4
5 6 7 8
9 0 1 0
R E P
T U N IN G P R O G
A - B M E M
P R E S E T S C A N R A N D O M
B A N D E N T E R V O L U M E
D IS P L A Y D IM M E R M U T E
IN F O
X R C - 2
AES COAX
Standby switch
Input selector key
Replay key
A-B segment replay key
Programmed play key
Random play key
Track scan key
Note: Keys not described are
not intended for the machine.
It is normal if there is no respons
pushing them..