Storage; Troubleshooting - Steinbach Poolrunner Battery+ Manual Del Usuario

11
2
4
1. Pull the two latches apart and lift off the top part
2. Take the filter unit
3
3. Thoroughly rinse the filter unit
4. Rinse the device after each use with plain tap water inside and out.
The device is clean.

Storage

1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Fully charge the device.
Recharging is required after at latest 3 months due to self-discharge.
4. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C) without direct
sunlight.

Troubleshooting

Fault description
The device cannot be switched on
and the status indicator is not lit.
The charge control indicator is not
lit.
The rechargeable battery running
time is shorter than expected.
The device does not work and the
status indicator blinks red.
The device cannot reach all spots.
The device does not function.
26
out of the bottom part .
4
with plain tap water.
3
Cause
The rechargeable battery is dead.
The rechargeable battery is
defective.
The charger is defective.
The water temperature is too low.
The rechargeable battery was not
completely charged.
The device has a fault.
The nozzle setting is not suitable.
The water circulation of the pool is
switched on.
There are foreign objects in the
drive.
12
3
4
.
2
Remedy
Charge the rechargeable battery.
Contact customer service.
Contact customer service.
Only use the device under the
permissible operating conditions.
See section "Technical data".
Charge the rechargeable battery
completely.
Contact customer service.
Change the setting of the nozzles.
Switch off the filter system of the
pool.
Contact customer service.