Cleaning The Main Filter - Koenic KVC 3121 A Manual De Instrucciones

Cleaning and care
Warning!
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Never immerse any electrical parts of the
product in water or in other liquids during
cleaning. Never place it under running
water.
Emptying the dust canister (Part O)
Fig. If the suction power diminishes, the dust
15
canister must be emptied and the filters
must be cleaned. We recommend to
empty the dust canister outside of the
house.
a) Remove the suction hose from the
dust canister. Press the unlocking
device and remove the filter by bringing
it forward.
b) To empty the dust canister, simply
press the release on the bottom so
that the bottom of the canister opens
and the dust falls out. Hold the dust
canister over a rubbish container whilst
you are emptying it.
c) Loosen the filter lid and remove the
entire filter insert from the dust
canister. Empty the remain dusty from
the dust canister.
d) Re-assemble all of the components
that have previously been removed.
Assembly is carried out in reverse order.

Cleaning the main filter

a) Loosen the filter lid and remove the
Fig. 16
entire filter insert from the dust
canister. Break down the filter into all
of its individual parts. Tap the filter to
remove the dust and clean all parts
with water and dry them thoroughly.
b) Re-assemble all of the components
that have previously been removed.
Assembly is carried out in reverse
order.
IM_ KVC3121A_160426_V02_HR.indb 17
Cleaning the motor filter
Remove the motor filter and tap it
Fig.
17
to remove the dust. Then re-insert it.
Reassemble all of the components
that have previously been removed.
Assembly is carried out in reverse order.
Warning!
Never use the vacuum cleaner without a
motor filter, as otherwise, the motor will soon
get dirty and will be subject to wear. If the
motor filter gets dirty, the suction power will
diminish.
Cleaning the exhaust air filter
Open the flap, take the filter out and
Fig.
18
tap it to remove the dust. Assembly is
carried out in reverse order. Insert the
filter in the right direction so that the
correct side is facing the motor.
Technical data
Rated Voltage : 220 - 240 V~, 50/60 Hz
Rated input power : 700 W
Protection class : II
• This is a general purpose vacuum cleaner
• The Erp test method is according to (EU)
No 666/2013, (EU) No 665/2013 & EN
60312:2013
• Please refer to below website for detail
technical information, or contact us for
technical document:
www.koenic-online.com
English
17
26/4/16 2:09 PM