Troubleshooting; Important - Black and Decker AD925 Manual De Instrucciones

DTC Description
P0442 Evaporative Emission System Leak Detected (Small Leak)
P0443 Evaporative Emission System Purge Control Valve Circuit
P0446 Evaporative Emission System Vent Control Circuit
P0449 Evaporative Emission Vent Valve Solenoid Malfunction
P0452 Evaporative Emission System Pressure Sensor/Switch Low Input
P0455 Evaporative Emission System Leak Detected (Gross Leak/No Flow)
P0456 Evaporative Emission System Leak Detected (Very Small Leak)
P0505 Idle Air/Speed Control System
P0507 Idle Air/Speed Control System Revolutions Per Minute Higher Than
Expected
Bank is a term used by car manufacturers to locate which row of cylinders on
NOTE:
the engine is impacted by a malfunction. Bank 1 refers to the side of the
engine that contains cylinder 1. Bank 2 refers to the side of the engine that does not
contain cylinder 1.
Error Message
Screen toggles between "Link" and "Error"
While operating on battery
power, no results are displayed.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.
Accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could
be hazardous.
All manuals and user guides at all-guides.com

Troubleshooting

Solution
If the ignition is on, disconnect the Tool
from the vehicle, turn the ignition off for
10 seconds, turn the ignition back on
and reconnect the Tool to the vehicle.
Your vehicle may not be OBD II
compliant/certified. Refer to the Vehicle
Emissions Control Information
Decal that is located in the engine
compartment and verify that the
vehicle is identified as "OBDII Certified".
If the decal does not identify
the vehicle as such, this Tool will
not work with your vehicle.
Make sure the batteries have been
installed correctly.
12