Premier 1034390 Guía De Uso Y Cuidado página 7

Installation (continued)
Pre-Installation
7
I I n n s s t t a a l l l l i i n n g g a a n n d d a a d d j j u u s s t t i i n n g g t t h h e e f f l l u u s s h h
P P L L A A N N N N I I N N G G I I N N S S T T A A L L L L A A T T I I O O N N
b b u u t t t t o o n n
Before beginning installation of this product, make sure all parts are present. Compare parts with the Hardware Included and Package Contents lists. If any
part is missing or damaged, do not attempt to assemble, install, or operate the product. Contact customer service for replacement parts.
□ Position the flush button mechanism (QQ) in tank lid so the
Estimated Assembly Time: 60 minutes
single drop button will align with blue button (half flush) on
top of the flush valve and double drop button aligns with
T T O O O O L L S S R R E E Q Q U U I I R R E E D D
the grey button (full flush).
□ Secure the flush button mechanism (QQ) in the tank lid by
hand tightening the lock nut (1).
□ The rubber tip on the bottom of the push rods leading from
Putty knife
the flush buttons should lightly touch the top of the levers
on the flush valve.
□ To increase the rod length, turn the rod locknut counter-
clockwise to loosen, then rotate the push rod counter-
H H A A R R D D W W A A R R E E I I N N C C L L U U D D E E D D
clockwise to increase exposed length. When the desired
length is achieved, turn the rod locknut clockwise, while
NOTE: Hardware not shown to actual size.
holding the push rod, until it is tightened.
P P a a r r t t D D e e s s c c r r i i p p t t i i o o n n
AA Floor bolt
BB Floor bolt hex nut
CC Wax ring
DD Plastic disc
EE Floor bolt wing nut
FF Bolt cap
GG Brass washer (Preassembled to Tank (A))
HH Rubber washer (Preassembled to Tank (A))
II Bolt (Preassembled to Tank (A))
JJ Hex nut (Preassembled to Tank (A))
KK Rubber sealing gasket
LL Oval metal washer
MM Wing nut
NN Lock bolt
OO Toilet seat washer
PP Lock nut
QQ Dual flush button
Carpenters
level
8
C C o o n n n n e e c c t t i i n n g g t t h h e e w w a a t t e e r r s s u u p p p p l l y y l l i i n n e e
□ Connect the water supply line (not included) between the
tank (A) and shut-off valve.
□ Tighten the tank connection coupling nut ¼ turn beyond
hand tight.
□ Turn on the supply valve and allow the tank (A) to fill.
□ Check for leakage at all connections and tighten or correct
Toilet water
as needed.
supply line
NOTE: Do not overtighten the tank connection.
Q Q u u a a n n t t i i t t y y
2
2
1
2
2
2
2
4
2
2
1
2
2
2
2
2
1
7
Please contact 1-800-831-8383 for further assistance.
7
3
Please contact 1-800-831-8383 for further assistance.
PREMIERFAUCET.COM
PREMIERFAUCET.COM