Attachments On Request; Battery; Battery Charger; Bars And Chains - ST MP 500 Li 48 Manual De Instrucciones

8. Battery power reserve is low
9. The battery charger is not
recharging the battery
If problems persist after having performed the above operations, contact your dealer.

15. ATTACHMENTS ON REQUEST

15.1 BATTERY

Different capacity batteries are available to
suit specific operating requirements (Fig. 28).
The list of approved batteries for this machine
is found in the "Technical Data" table.

15.2 BATTERY CHARGER

Device used to recharge the battery: fast
(Fig. 29.A), standard (Fig. 29.B).

15.3 BARS AND CHAINS

The "Correct bar and chain combination
table" contains a list of all possible
combinations between bar and chain,
indicating those which may be used on each
machine, marked with the symbol "".
The same table also provides the
specification data for all chains and bars
approved for use on each machine.
Only use the replacement bars
and chains listed in the table. The use
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental
conditions
Dirty contacts
The battery charger
is not energised
Faulty battery charger
of unapproved combinations may be
hazardous and cause serious injuries to
operators and damage the machine.
application and use of the bar and chain
are actions made solely by the user, at
his own discretion, the latter assumes
responsibility for damages of any kind
arising from such actions. When in doubt
or if lacking knowledge of the specifics
of each bar or chain, contact your dealer
or an authorised garden centre.

15.4 BATTERY BACKPACK

Device which allows the housing of
two batteries and provides the power
needed to operate the machine.
It is equipped with the cable to connect to
the machine (Fig. 1.N) and a selector switch
(Fig.
two batteries ( position "1" and "2") and "OFF".

15.5 BATTERY SIMULATOR

Device that, if inserted in the machine housing,
allows the use of the battery backpack.
EN - 17
Optimise operations
(par. 7.2.1)
Use a second battery or
extended battery (par. 7.2.1)
Purchase a new battery
Check it is correctly
inserted (par. 7.2.3)
Recharge the battery in places
with suitable temperatures
(see battery/battery charger
instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an
original spare part
If the problem persists,
refer to the battery/
battery charger manual
In consideration that the selection,
13.B) which allows you to select one of the