Technical Data; Ec Declaration Of Conformity - HSM Classic 105.3 Instrucciones De Servicio

9 Technical data

Cutting type
Shred size (mm)
Sa fe ty ra ting German DIN 66399
Cutting ca pa ci ty* (Sheet) DIN A4
Weight
Cutting speed
Lo ading width
Voltage
Power for the maximum number of sheets
Operating mode
Dimensions W x D x H (mm)
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL)
Volume of shred. mat. container
Noise level (Idle running/ load)
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one specifi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.

EC Declaration of Conformity

The manufacturer HSM GmbH + Co. KG, Austraße 1 - 9, 88699 Frickingen / Germany hereby declares that the
design and construction of the supplied version of the machine HSM Classic 105.3 meet the fundamental health and
safety requirements of the following EC directives:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards:
EN 953
EN 13849-1
EN 60204-1
EN 61000-6-1
EN 62061
Frickingen, 15.1.2014
14
All manuals and user guides at all-guides.com
5.8
P-2 / O-2
T-2 / E-2
70 g/m 22 - 24
2
80 g/m 2 17 - 19
EN 1037
EN ISO 13857
EN 60950-1
EN 61000-6-2
ppa. Hubert Kötzinger - Chief Technical Offi cer (CTO)
Classic 105.3
english
Strip cut
3.9 1.9 3.9 x 30
P-2 / T-2 P-3 / T-2 P-4 / T-4
E-2 E-2 E-3 / F-1
16 - 18 12 - 14 12 - 14
13 - 15 9 - 11
11.5 kg
80 mm/s
240 mm
230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
440 W
Continuous operation
375 x 281 x 583
-10 °C to +25 °C
max. 90 %, without condensation
max. 2,000 m
33 l
58 dB(A) / 59 - 63 dB(A)
EN 1088
EN 55014-1
EN 61000-3-2
EN 61000-6-3
Cross cut
1.9 x 15 0.78 x 11
P-6 / F-3
P-5 / T-5
E-4 / F-2
9 - 11 5 - 6
9 - 11 7 - 9 4 - 5
12.5 kg
90 mm/s
EN ISO 12100
EN 55014-2
EN 61000-3-3
EN 61000-6-4
01/2014