Charging Battery; Important - Circutor MD5060e Manual De Uso

3. Charging battery

The MD-5060e uses a rechargeable LiFePO4 12 V - 6000 mAh.
At the end of battery useful life, the battery must be recycled or
disposed of properly, in order to protect the environment.
Charging procedure:
· Check if the MD-5060e is turned-off and connect it to the mains (AC
adapter).
· The charging indicator (
remain that way until the battery is totally charged. Then the light will
remain green and keep in that way until the MD-5060e is disconnected
of the mains.
Alternate green and red
lights
Steady red light
Flashing red light
Steady green light
The rechargeable battery does not have "memory effect" and there are no
restrictions to start charging it as many times as is needed. However the battery
could be damaged if remains in deep discharge for a while.
To avoid this effect, charge the battery before left the equipment in storage and
don't let pass more than 30 days without recharge, even if the instrument wasn't
used (under storage, the battery loses part of its charge).
IMPORTANT: while the equipment is connected to the mains supply the START
key is inhibited, so you will not be able to make measurements.
All manuals and user guides at all-guides.com
Evaluation of the battery initial status when the
source is connected, during one second.
Battery under charge.
The battery was not successfully charged. It
denotes some trouble in the battery charging
process.
The charge has successfully finished. The battery
is OK.
45
) will turn on red and will