Air Filter Cleaning; Storing The Appliance; Storing The Unit; Problems And Solutions - TREVIDEA g3ferrari MAGNIFICO Manual Del Usuario

CLEANING THE AIR OUTLET FILTER
- Rotate the air outlet grid and remove it (Figure C)
- Remove the filter output from the grid.
- Wash the filter with warm water and DRY IT COMPLETELY.
CAUTION: It is recommended to clean or replace the filter every 6 months.

STORING THE APPLIANCE

This appliance can be folded back on itself in order to take up as little space as possible. To fold it up, press
the release button on the handle (4) and fold the handle as shown in the figure.
Store the unit with care in a suitable place far from heat sources and cold spots.

PROBLEMS AND SOLUTIONS

PROBLEM
The cleaner does not
work
Suction power is
weak
Dirt comes out of the
container
Unit cannot vacuum

MAINTENANCE AND CLEANING

CAUTION: before starting any cleaning/maintenance operations, unplug the unit from the electrical
outlet.
MAINTENANCE
Normally this vacuum cleaner is not noisy. But when the dust container is full or the HEPA filter is clogged,
the noise emitted changes, so the suction power. In addition, thanks to the transparent container, you can see
the amount of dirt making it very easy to understand when you need to empty the container. Even the filters
should be cleaned periodically. These filters can also be damaged or exhausted (HEPA filter) and should be
replaced with new filters. Emptying the dust container and cleaning the filters as stated in this booklet, you
will avoid stressing the motor.
CLEANING
Clean the main body with a damp non-abrasive cloth, avoiding the use of aggressive detergents or abrasive
cleaners, which could ruin the aesthetic parts of the device.
The cloth should not be too wet, since the water penetrating the device, can seriously damage it. Cleaning
filters by following the specific instructions on this guide.
CAUSE
The unit is not correctly connected
Electricity is down.
The container is full.
The unit is obstructed..
Filters need to be cleaned.
Container is full.
Not correctly installed.
Broken container.
Blocked hose.
Dust container is full.
SOLUTION
Plug the unit.
Check the distribution board.
Empty the container.
Unplug and check if something obstructs the unit
Clean or change the filter.
Empty the container and installi t again.
Replace the container.
Remove objects inside the hose.
Empty the container and clean the filters
15