Eiko SEN5A/PIR/Z10 Manual Del Usuario página 5

COMMISSIONING TOOL SETTINGS:
1. PRESS BUTTON, THE REMOTE CONTROL LEDS WILL SHOW THE LATEST PARAMETERS YOU SET.
• NOTE: IF YOU PUSH
2. PRESS OR ENTER IN THE SETTING CONDITION, THE PARAMETER LEDS OF REMOTE CONTROL WILL
FLASH TO BE SELECTED, NAVIGATE TO THE DESIRED SETTING BY PRESSING
PARAMETERS.
3. PRESS OK TO CONFIRM ALL SETTINGS.
4. AIM AT THE TARGET SENSOR AND PRESS TO UPLOAD THE NEW PARAMETER, THE LED LIGHT WHICH THE
SENSOR CONNECTS WILL ON/OFF AS CONFIRM.
• NOTE: THE SETTING WORKS KEY STEP IS BY PRESSING
• NOTE: THE LED LIGHT WHICH THE SENSOR CONNECTS WILL FLASH ON/OFF AFTER GETTING THE NEW
PARAMETER AS CONFIRMATION.
• NOTE: IF YOU PRESS
WERE SENT.
CHANGE MULTIPLE SETTING OF SENSORS WITH SMART PHOTOCELL SENSOR:
1. PRESS THE REMOTE LED INDICATORS WILL SHOW THE LATEST PARAMETERS.
2. PRESS OR ENTER IN THE SETTING CONDITION, THE PARAMETER LED INDICATORS OF REMOTE CONTROL
WILL FLASH TO BE SELECTED.
3. PRESS , 2 LED INDICATORS WILL FLASH IN DAYLIGHT SENSOR SETTINGS, SELECT DAYLIGHT
AS SETPOINT TO LIGHT ON AUTOMATICALLY, SELECT DAYLIGHT
AUTOMATICALLY.
4. PRESS TO CONFIRM ALL SETTING AND SAVING.
5. AIM AT THE TARGET SENSOR AND PRESS
SENSOR CONNECTS WILL ON/OFF.
• NOTE: IS DISABLED BY DEFAULT.
• TO SET OR REMOVE THE SMART DAYLIGHT FUNCTION, PRESS
MODE.
• WHEN THE SMART DAYLIGHT FUNCTION IS ACTIVED, 2 LED INDICATORS WILL FLASH IN THE DAYLIGHT SENSOR
SETTING. SELECT DAYLIGHT
AS SETPOINT TO TURN LIGHT OFF AUTOMATICALLY.WHEN SMART DAYLIGHT SENSOR CLOSE, LED
INDICATOR WILL FLASH IN THE DAYLIGHT SENSOR SETTING FOR CHOOSE DAYLIGHT SENSOR THRESHOLD.
• WHEN THE SMART DAYLIGHT SENSOR OPEN, THE STAND-BY TIME IS ONLY
• SMART DAYLIGHT SENSOR TAKES PLACE OF NORMAL PHOTOCELL SENOR AND WORKS INDEPENDENTLY.
• SEE DAYLIGHT SENSOR FUNCTION.
CORRIDOR FUNCTION:
• THIS FUNCTION INSIDE THE MOTION SENSOR TO ACHIEVE TRI-LEVEL CONTROL, FOR SOME AREAS WHICH
REQUIRE A LIGHT CHANGE NOTICE BEFORE SWITCH-OFF. THE SENSOR OFFERS 3 LEVELS OF LIGHT: 100%
DIMMED LIGHT (NATURAL LIGHT IS INSUFFICIENT, OFF, AND 2 PERIODS OF SELECTABLE WAITING TIME:
MOTION HOLD-LIME AND STAND-BY PERIOD, SELECTABLE DAYLIGHT THRESHOLD AND FREEDOM OF
DETECTION AREA.
• WITH SUFFCIENT
NATURAL LIGHT,
THE LIGHT DOES
NOT SWITCH ON
WHEN PRESENCE IS
DETECTED.
BUTTON BEFORE, YOU MUST PUSH
BUTTON, THE REMOTE LED INDICATORS WILL SHOW THE LATEST PARAMETERS WHICH
TO UPLOAD THE NEW PARAMETER. THE LED LIGHT WHICH THE
AS SETPOINT FOR LIGHT TO SET AUTOMATICALLY, SELECT DAYLIGHT
• WITH INSUFFICIENT
NATURAL LIGHT, THE
SENSOR SWITCHES
ON THE LIGHT
AUTOMATICALLY
WHEN PRESENCE IS
DETECTED.
BUTTON TO UNLOCK THE SENSOR.
OR , ENTER IN THE SETTING CONDITION.
AS SETPOINT TO LIGHT OFF
WHEN REMOTE CONTROL IS IN SETTING
• AFTER HOLD-TIME,
THE LIGHT DIMS TO
STAND-BY LEVEL IF
THE SURROUNDING
NATURAL LIGHT IS
BELOW THE DAYLIGHT
THRESHOLD.
TO SELECT THE NEW
• LIGHT SWITCHES OFF
AUTOMATICALLY AFTER
THE STAND-BY PERIOD
ELAPSES.