ARAG 466970X0 Instalación Uso Y Mantenimiento página 9

3.3 Control box connection to the hydraulic control unit (Fig. 3)
Connect the box to the hydraulic control unit by means of the section control termination cables (to
be purchased separately - Ref. ARAG general catalog).
• Open connector slide (1 in Fig. 3).
• Position connector (2) and insert it inside socket, then press: during this operation, take care
not to bend the electric contacts.
• Close slide (3) until it locks in place.
To avoid short-circuits, connect the power cable only after completing installation.
4 USE
LH first section
Opening/Closing
LH second section
Opening/Closing
LH boom variable
geometry control
Boom unlocking/
locking
Depending on the control box model you have purchased, some functions could not be
available.
opening
closing
opening
closing
lifting
lowering
unlocking
locking
LED signaling that
function is enabled
inclination
to the left
Boom
leveling
inclination
to the right
9
RH first section
Opening/Closing
RH second section
Opening/Closing
RH boom variable
geometry control
lifting
Boom height
lowering
opening
closing
opening
closing
lifting
lowering