Software Setup - Korenix JetPort 5801 Manual Del Usuario

All manuals and user guides at all-guides.com
3.4 Connect the serial device to the unit DB9 male port by the pin assignment table. The
Long-Range Termination switch can configure 120ohm termination for RS422 / 4-wire RS485
/ 2-wire RS485.

Software Setup

1. Install JetPort Commander: Insert the CD and auto-run the program. If the setup does
not auto-run, select "JetPort 5801", and "Operation System", run JetPort Setup.exe to install
Windows utility, JetPort Commander.
2. Find the JetPort unit: JetPort Commander will broadcast the network and search all
available JetPort units in the network.
3. Configuring the JetPort unit:
3.1 Check on the JetPort unit and select "Add" for further configuring the unit.
3.2 Select "Static IP" if you want to specify the network parameters, or select "Using DHCP" if
you want dynamic IP configuration for the JetPort unit.
3.3 Go to "Wireless" and assign Network Type to "Infra" (Infrastructure mode). Press "SSID
Scan" and select the available SSID, or manually configure the SSID in the SSID field.