Makita DTD172 Manual De Instrucciones página 12

NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
Quick mode-switching function
What you can do with the quick mode-switching function
The quick mode-switching function saves the time for changing the application mode of the tool. You can switch to
your desired application mode by just pressing the quick mode-switching button. It is helpful when doing a repetitive
work which requires to switch between two application modes alternately.
EXAMPLE If you have a work to use T mode and max impact force, register the max impact force for quick
mode-switching function. Once register it, you can switch to the max impact force from T mode by just one click
of the quick mode-switching button. Also, you can return to T mode by pressing the quick mode-switching button
again.
Even if the tool is in other application mode than T mode, pressing the quick mode-switching button changes to
max impact force. It is convenient for you to register a application mode that you frequently use.
You can choose one of following application modes for quick mode-switching function:
Impact force
• 4 (Max)
• 3 (Hard)
• 2 (Medium)
• 1 (Soft)
Assist type
• Wood mode
• Bolt mode
• T mode (1)
• T mode (2)
Registering application mode
To use the quick mode-switching function, register your desired application mode to the tool beforehand.
1. With the button
2. Press and hold the button
application mode blinks.
► Fig.11: 1. Quick mode-switching button 2. Button
NOTE: You can overwrite the current application mode with new one by performing the procedure above.
Using the quick mode-switching function
When the tool is in the mode that is not registered, press the quick mode-switching button to switch to the registered
application mode. The tool switches between the registered application mode and last application mode every time
you press the quick mode-switching button. The front lamps on both sides will flash once when switching to the regis-
tered application mode.
The lamp of the registered application mode will blink when using the registered application mode.
Erasing the registered application mode
Press and hold the button
NOTE: After erasing the registered application mode, the quick mode-switching button works for changing the
impact force.
or , choose your desired application mode.
and the quick mode-switching button at the same time until the lamp of desired
and button at the same time until all impact force grade lamps blink.
12 ENGLISH
.