Abicor Binzel CAT2 Instructivo De Servicio página 44

11 Dismounting
11 Dismounting
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, mounting, dismounting and
repair work, the following instructions must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Disassembly may only be carried out by qualified personnel
• Observe also the operating instructions of the welding components, such
• Observe the information provided in the following section:
 Fig. 6 Mount CAT2 on the robot on page EN-15
1 Remove the parts to be disconnected.
EN - 22
All manuals and user guides at all-guides.com
DANGER
(in Germany see TRBS 1203).
as welding power source and welding torch.
 8 Putting out of operation on page EN-19.
CAT2