Klein Tools MM700 Manual De Instrucciones página 5

al SpecificationS
GinG)
ion accuracy
±(5.0% + 35 digits)
±(3.0% + 5 digits)
F
±(5.0% + 5 digits)
or 600V AC RMS
inG)
Hz
z
±(1.0% + 5 digits)
z
or 600V AC RMS
±(1.2% + 2 digits)
0kHz
or 600V AC RMS
1°F ±(2.0% + 9°F)
1°C ±(2.0% + 5°C)
All manuals and user guides at all-guides.com
electrical SpecificationS
otHer MeaSureMent applicationS
Maximum input: 100V RMS in Voltage setting,
600V DC or 600V AC RMS in all other settings
• Diode test: 1.5 mA max, open circuit voltage 3.0V DC
• continuity check: Audible signal when resistance <50Ω,
• low impedence (low Z): Input impedence >3kΩ
• auto power off: After ~30 minutes of inactivity
• Sampling frequency: 3 samples per second
• Bar Graph: 41 segment, 10-15 samples per second
• overload: "OL" indicated on display, 1000V RMS in voltage
settings, 600V RMS in all other settings
• polarity: "-" on display indicates negative polarity
• Display: 3 ¾ digit, 4000 Count LCD, TRMS technology
to ensure safe operation and service of the meter, follow these
instructions. failure to observe these warnings can result in
severe injury or death.
• Before each use verify meter operation by measuring a known
voltage or current.
• Never use the meter on a circuit with voltages that exceed the
category based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CAT IV rated test leads.
• Ensure meter leads are fully seated, and keep fingers away
from the metal probe contacts when making measurements.
• Do not open the meter to replace batteries while the probes
are connected.
• Use caution when working with voltages above 25V AC RMS
or 60V DC. Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock,
replace batteries when a low battery indicator appears.
• Do not attempt to measure resistance or continuity on a live
circuit.
• Always adhere to local and national safety codes. Use personal
protective equipment to prevent shock and arc blast injury
where hazardous live conductors are exposed.
• Meter is IP42 dust & water resistant. Following any contact
with water, thoroughly dry meter and test lead jacks prior to
subsequent use.
MM700-1390112ART.indd 5
Dwg Name: MM700-1390112ART
Dwg No: 1390112
ECO No: 20617
Pkg Dwg Ref: 1290186
Color Reference: N/A
max test current 0.35mA
Max input 600V RMS
WarninGS
Rev: E
5
9/21/2015 2:44:46 PM