thrown out.
Overflowing liquid will run onto the underlay, which is why this needs to
be waterproof.
• When steaming, make sure there is never too much or too little water
in the appliance.
• Do not place the appliance immediately underneath a suspended
cupboard, as steam escapes upwards and might damage your
furniture.
• Use only clean drinking water to generate steam.
• The manufacturer and importer accept no liability for damage caused
by an inadequate power supply or improper electrical installation in
your building. If in doubt, consult a qualified electrician.
5. Unpacking and setting up
A number of individual parts are given a protective film of grease in
production. When you use the appliance for the first time, run it
without any foodstuffs to allow such residues to evaporate.
Note: When you use the appliance for the first time you may notice a
slight odour as the motor becomes hot. This is harmless.
Make sure the room is adequately ventilated.
1. Remove the individual parts from their packaging.
2. Check that the individual parts are all present and are undamaged.
3. Clean the appliance thoroughly before using it for the first time
4. Always place the appliance on a level, dry, non-slip waterproof surface
to prevent it tipping over or sliding off.
Caution! Overflowing liquid will run onto the underlay, which is why
this needs to be waterproof. The appliance is now ready to use.
6. Operating the appliance
For safety reasons, the settings described in this section may only be
selected when the appliance has been fully assembled
the blender jug" or "8. Steaming").
11
(see "7. Using