Pulsar TPS 7 Manual Del Usuario página 2

TPS 7 Battery Charger
TPS 7 charger is designed to charge TPS 7 rechargeable batteries used with thermal imaging fusion binoculars
TRIONYX and supports USB Power Delivery fast charging technology using a standard charging kit of your TRI-
ONYX device (USB Type-C cable, power adapter).
PACKAGE CONTENTS TECHNICAL SPECIFICATIONS
• SKU
TPS 7 charger
•
Power adapter Power adapter input voltage
• Power adapter output voltage/current
USB Type-C Cable
•
Operating Manual Charging voltage/current
Rated output voltage
Battery compatibility
Charging temperature range
Dimensions
Weight
Improvements may be made to the design and software of this product to enhance its user features.
The current version of the Operating Manual can be found on the website www.pulsar-vision.com
BATTERY CHARGING
• Insert the battery* (1) along the guide to the stop into the TPS 7 charger slot (4) (see. Fig.).
• Connect the plug of the USB Type-C cable (7) to the USB Type-C connector of the power adapter (3). Plug the
power adapter into a socket 100-240 V (6) (110 V socket for US).
• Connect the other end of the USB Type-C cable to the USB Type-C connector (5) of the charger (4).
• LED indication (2) displays battery charging level (see Table).
LED indication (2) in battery charging mode
Battery level is from 0% to 25%
Battery level is from 26% to 50%
Battery level is from 51% to 80%
Battery level is from 81% to 99%
The battery is fully charged. It can be
disconnected from the charger.
Defective battery. It is forbidden to use the
battery.
* Purchased separately or supplied as package contents of a device.
** Standby mode – an operating mode in which the battery is inserted into the charger, but the power adapter is
not connected. In this mode, the indication is on for 10 seconds.
Attention! When using a power adapter that does not support USB Power Delivery fast charging technology, the
flicker frequency of LED indicators decreases by 3 times and charge time increases.
Attention! The charger heats up during fast charging. Excess heat is removed through the radiator and does not
affect the device operation.
PRECAUTIONS
•
Always use this charger or TPS 7 charger supplied with the device to charge TPS 7 batteries. Using the unsuitable
charger can cause irreparable damage to the battery and fire.
• Do not charge the battery immediately after brining it from cold to warm. Wait at least 30 minutes for the
battery to warm up.
•
Do not leave the battery unattended while charging.
•
Do not use the charger if it has been modified or damaged.
• Do not leave the battery in a charger connected to the network after charging is complete.
•
Do not expose the battery and charger to high temperatures and naked flame.
•
Do not disassemble or deform the battery or charger.
•
Do not drop and strike the battery and charger.
79184
100-240 V (110 V for US)
5 V 2 A; 9 V 3 A
5 V 2 A; 9 V 3 A
4.2 V
TPS 7
0°С...+35°С (+32°F...+95°F)
64х34х45 mm (2.52x1.34x1.77 inches)
0.08 kg (2.82 oz)
LED indication (2) in standby**
Battery level is from 0% to 25%
Battery level is from 26% to 50%
Battery level is from 51% to 80%
Battery level is from 81% to 99%
The battery is fully charged. It can be
disconnected from the charger.
Defective battery. It is forbidden to use the
battery.
•
The charger is not designed to be immersed in water.
•
Keep the charger out of the reach of children.
RECOMMENDATIONS FOR USE
• The battery is to be charged at an ambient temperature of 0 °C...+35 °C (+32°F...+95°F). Otherwise,
lifespan of the battery will decrease significantly.
•
Do not use the charger at temperatures outside the range of 0 °C...+35 °С (+32°F...+95°F).
1 4
6
3
7
2
5
2