Youin BK3000 Manual De Usuario página 24

8. LCD Display
· Speed Limit Setting
SPD indicates max speed limit. The selectable range
of the max speed setting value is between 5km/h
and 46km/h. Short press the UP or DOWN button
increase or decrease value setting. The default max
riding speed is uploaded by controller, press UP or
DOWN button to increase or decrease speed limit
until the required value displayed. Long press the
ON/OFF button for more than 1 second to confirm
and exit setting state.
Speed limit display
· Backlight Brightness
BLG indicates backlight level. Parameters 1, 2, 3, 4, 5
can be set to indicate backlight brightness. 1 is the
darkest, 3 is standard light, 5 is the brightest. The
default value of display is determined by controller.
Short press UP or DOWN button adjust backlight
brightness parameter. Long press ON/OFF button
to confirm and exit setting state.
Backlight brightness setting
· Switch Between Imperial and Metric Units
Unt represents unit switching setting, the speed
and mileage unit can be changed by UP or DOWN
button. Short press ON/OFF button to confirm,
the display will show "OK" word to prompt that the
reset is complete and return to the setting selection
interface. The default unit of display is Metric
system.
Unit switch
· Display Software Version
DPS indicates display software version. And the
display software version is confirmed by program
and CAN NOT be adjusted.
Display software version display interface
· Controller Software Version
CLS indicates controller software version. And the
controller software version is uploaded by controller
and CAN NOT be adjusted.
Controller software version display interface
24
YOU-RIDE EVEREST