Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
15) To disconnect the heater, turn controls to off, then remove the plug from the outlet.
16) To prevent possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked.
17) A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or
flammable liquids are used or stored.
18) "SAVE THESE INSTRUCTIONS"
NO USER-SERVICABLE PARTS ARE INSIDE THE UNIT. REFER ALL REPAIRS TO AN AUTHORIZED SERVICE
REPRESENTATIVE AT COLORADO TRI-FLO SYSTEMS, LLC.
Operating Instructions
This is a free standing heater. It requires 1 foot (0.3 meters) of clearance around all of its sides. Your unit
is shipped as a corded unit. When used as configured (corded) out of the box, its portability allows you
to move the heater from one location to another.
Wiring
In accordance with ANSI/NFPA 70, the ER10000W.01-230V heater unit comes with a 6 foot cord and a
plug. The plug must use an outlet capable of carrying 230 volts, 10000 watts, and 50 amps.
Over Circuit Protection. Use only on a 50 ampere branch circuit.
Maintenance
Keep small objects from entering the unit.
When not in use for long periods the heater may collect dust on it and in it. Wipe down the outside shell
with a damp cloth and if possible use compressed air to blow out the inside. Make sure unit is
unplugged and cool before preforming any maintenance.
Make sure unit is unplugged and cool before preforming any maintenance.
Controls
The heating unit has an on/ off switch or a bulb thermostat mounted on the unit.
Installation Instructions
Bulb Thermostat Installation Instructions
Publicidad
